The DBX DriveRack 260 is a top - notch loudspeaker management system crafted for live or contractor sound scenarios. It offers comprehensive system control over equalization, dynamics, and routing. With its robust processing, it features a linkable 28 - band graphic and 9 - band parametric EQ, and the built - in compressor manages system dynamics. DBX's PeakStopPlus® limiters add an extra layer of protection against excessive power and sudden transient spikes. Before tweaking the EQ, users can use the internal Pink Noise Generator and Real Time Analyzer to understand room acoustics. It also comes with an easy - to - assign, flexible alignment time delay and a useful 15V phantom powered mic input for better room management. A high - quality control processor like this helps optimize room acoustics and enhance overall system performance without compromising audio quality. It has built - in custom templates for specific amplifier and speaker combos, and users can easily adjust setups via the Wizard setup system and complete DriveWare™ GUI control. The DriveRack 260, derived from a proven processor series, is an essential tool for maximizing audio quality in various settings, thanks to its simple and intuitive interfaces. Key features include compression and limiting, graphic and parametric equalization, full bandpass, crossover, and routing configurations, feedback elimination, a built - in sub - harmonic synthesizer, pink noise generator and full - time RTA, 2.7 seconds of alignment and zone delay, auto - EQ function, and auto gain control. Technical specs: Frequency Response is 20Hz to 20kHz, Dynamic Range is 100dB unweighted >107dB weighted, it has (2) XLR - female and (1) XLR RTA Mic input for input connections, (6) XLR - male for output connections, input impedance >40 kOhms, output impedance 120 Ohms, maximum input level 34dBu with input jumpers in +30 position, maximum output level 22dBu, sample rate 48kHz, RTA Mic Phantom Voltage 15 volts, crosstalk (Main Outputs) >100dB, and THD & Noise 0.002% typical at +4dBu, 1kHz, 0dB input gain.
Using the DBX DriveRack 260 is straightforward. First, familiarize yourself with the room acoustics using the internal Pink Noise Generator and Real Time Analyzer. Then, you can start adjusting the equalization settings according to your needs. The system offers both graphic and parametric EQ, so you have plenty of options to fine - tune the sound. When it comes to dynamics, the built - in compressor and PeakStopPlus® limiters work automatically to keep the sound balanced and protect your equipment. For room management, use the alignment time delay and the 15V phantom powered mic input. If you're using specific amplifier and speaker combinations, take advantage of the built - in custom templates and the Wizard setup system to quickly set up the device. Remember, when making changes, use the DriveWare™ GUI control for an easier experience. As for maintenance, keep the device in a clean and dry place. Avoid exposing it to extreme temperatures or humidity. Regularly check the input and output connections to ensure they are secure. If you notice any issues, refer to the user manual or contact customer support.
