The DigitaLinx DL-HDE100 is an outstanding HDMI HDBaseT extension set. It can transmit HDMI signals (supporting 1080p, 4Kx2K (UHD), and 3D with HDCP 2.2), Ethernet, bidirectional IR, and RS232 up to 100 meters via a single twisted pair cable. With built-in surge protection and diagnostic LEDs, installations are easy and reliable. The flexible power design lets you power the units at either the TX or RX end, and only one power supply is needed. The 12-volt power supply has a screw-on connector to prevent accidental disconnection. Key features include a complete set with TX, RX, mounting tabs, IR flasher/sensor, and power supply. It can extend HDMI signals up to 4K (4K for 70m / 1080P for 100m), bi-directional IR, RS232, and ethernet. It's HDCP 2.2 compliant, offers bidirectional wideband IR and RS232 pass-through, 100-BaseT Ethernet pass-through, a flexible power design, and a locking power connector.
Using the DigitaLinx DL-HDE100 is easy. First, connect the TX unit to your HDMI source and the RX unit to your display. Then, use a single twisted pair cable to connect the two units. You can choose to power the set at either the TX or RX end with the included 12-volt power supply and secure it with the screw-on connector. When it comes to maintenance, keep the units in a dry and cool place. Check the diagnostic LEDs regularly to make sure everything is working properly. If there's a power surge, the built-in surge protection will safeguard the units. Avoid pulling on the cables too hard to prevent damage. If you have any questions, feel free to reach out to our support team.
