Intelix AVO-USB-H Full-Speed USB Extender Dongle, Host Side

The Intelix AVO-USB-H full-speed USB extender dongle on the host side is a great solution for extending USB signals. It can transmit low-speed USB 1.0, 1.1, and 2.0 signals up to 330 feet and full-speed USB 1.0, 1.1, and 2.0 signals up to 100 feet over twisted pair cabling. This extender is installed at the host location to connect peripherals from a remote client-side extender. It's plug-and-play, no driver software is needed, and it uses the same USB circuit as other USB bus power devices for flexible installation. Key features include USB 2.0 full speed 12Mbps with USB 1.1 legacy support, cable lengths up to 330 feet on U/UTP category 5/5e/6, not for USB 2.0 high speed, no external power required using the host device's 5V power, USB 'A' male (host) to RJ45 jack connectivity, requires a compatible client end, and is compatible with 'New' Promethean Active Panel Displays.

Using the Intelix AVO - USB - H full - speed USB extender dongle is quite simple. First, make sure you have a compatible client end. Then, connect the USB 'A' male (host) of the dongle to your host device. The device will draw power from the host's 5V supply, so no external power is needed. After that, use the RJ45 jack to connect it to the appropriate cabling (U/UTP category 5/5e/6). Remember, it can transmit low - speed USB signals up to 330 feet and full - speed up to 100 feet. This dongle supports USB 2.0 full speed 12Mbps and also has USB 1.1 legacy support, but it's not for USB 2.0 high speed. As for maintenance, keep it clean and dry. Avoid exposing it to extreme temperatures or physical damage. If you face any issues, check the connections and make sure your host device is compatible.