Product Description
The Sony VPL-CH350 3LCD WUXGA projector is a great choice for basic installation. It offers an amazing 4000 lumens of brightness and ultra - high - quality WUXGA resolution images. With Sony's 3LCD BrightEra panel technology, you'll get better picture quality, much brighter visuals, high efficiency, stable colors, and long - lasting performance. This projector comes with a stylish design that can fit in any decor. It provides installation flexibility, eco - friendly features, and low overall cost. The lens shift/zoom and image correction features make it easy to project a perfect image on the screen, even from an off - angle. Key features include high - resolution WUXGA images, 3LCD BrightEra technology for natural and vivid colors with 4000 lumens brightness, fine lens shift (vertical: +/- 5%, horizontal: +/- 4%), a blend - in design, a 1.5:1 to 2.2:1 throw ratio, and advanced energy - saving features. Technical specs: It has a 3 LCD system, 0.64” (16.3 mm) x 3 BrightEra LCD Panel with a 16:10 aspect ratio, 6,912,000 (1920 - 1200 - 3) pixels, manual focus, zoom, and lens shift. The throw ratio is 1.5:1 to 2.2:1. It uses an ultra - high - pressure mercury lamp of 250 W type, with lamp replacement times of 3000 H (High mode), 4000 H (Standard mode), and 5000 H (Low mode). Dimensions are approximately 406 - 113 - 330.5 mm (15 31/32 - 4 7/16 - 13 inches).
Using the Sony VPL - CH350 projector is easy. First, find a good spot for installation. You can adjust the lens shift and zoom to fit the image on the screen, even if you're projecting from an odd angle. Once it's set up, turn it on and connect your device. For the best results, keep it in a moderately lit room since it has 4000 lumens of brightness. When it comes to lamp replacement, remember that the lamp life varies depending on the mode you use. In high mode, you'll need to replace the lamp after about 3000 hours, 4000 hours in standard mode, and 5000 hours in low mode. To maintain your projector, keep it clean. Use a soft, dry cloth to wipe the exterior. Don't block the ventilation holes to prevent overheating. And always turn it off properly following the shutdown procedure to avoid damage.
